Cisco 3020 - Catalyst Blade Switch Release Note page 19

sync
vlan_assign
voice
webauth
Defaults Authentication debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(50)SE
Usage Guidelines The undebug authentication command is the same as the no debug authentication command.
Related Commands Command
authentication
control-direction
authentication
event
authentication
fallback
authentication
host-mode
authentication open Enables or disables open access on a port.
authentication
order
authentication
periodic
authentication
port-control
authentication
priority
authentication
violation
show
authentication
OL-18274-02
(Optional) Display operational synchronization authentication manager
debug messages.
(Optional) Display the VLAN-assignment debug messages.
(Optional) Display the voice-VLAN debug messages.
(Optional) Display web authentication manager debug messages.
Modification
This command was introduced.
Description
Configures the port mode as unidirectional or bidirectional.
Sets the action for specific authentication events.
Configures a port to use web authentication as a fallback method for clients that
do not support IEEE 802.1x authentication.
Sets the authorization manager mode on a port.
Sets the order of authentication methods used on a port.
Enables or disables reauthentication on a port.
Enables manual control of the port authorization state.
Adds an authentication method to the port-priority list.
Configures the violation modes that occur when a new device connects to a port
or when a new device connects to a port after the maximum number of devices
are connected to that port.
Displays information about authentication manager events on the switch.
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(50)SE and Later
Documentation Updates
19