Documentation Updates - Cisco 3020 - Catalyst Blade Switch Release Note

Resolved Caveats
These sections describe the caveats that have been resolved in this release:
•
•
•
•
•
•
•
•

Documentation Updates

This section contains these documentation updates:
•
•
•
OL-14130-02
CSCse06827
When dynamic ARP inspection is configured on a VLAN, and the ARP traffic on a port in the VLAN
is within the configured rate limit, the port might go into an error-disabled state.
The workaround is to configure the burst interval to more than 1 second.
CSCsg81334
If IEEE 802.1x critical authentication is not enabled and the RADIUS authentication server is
unavailable during MAC authentication bypass (MAB) reauthentication, when the RADIUS server
comes back up, MAB now correctly authenticates previously authenticated clients.
CSCsh30966
This message no longer appears when the ternary content addressable memory (TCAM) is full:
%PLATFORM_PM-3-HOSTACCESSFAIL: Unable to configure hardware to restrict host access on
Fa1/0/47. Port may not behave as expected.
CSCsi08513
MAC flap-notification no longer occurs when a switch is running VLAN bridge spanning-tree
protocol (STP) and fallback bridging is configured on the VLANs running STP.
CSCsi10584
Multiple Spanning-Tree Protocol (MSTP) convergence time has been improved for Cisco IOS
Release 12.2.
CSCsi75246
When IEEE 802.1x and port security is enabled, port security now relearns the supplicant address.
CSCsi81401
When changing the administrative state of a port using the snmpset command, the switch no longer
fails.
CSCsl22576
You can use Device Manager to upgrade the switch from Cisco IOS Release 12.2(35)SE through
Cisco IOS Release 12.2(40)SE1 (the LAN Base image) to Cisco IOS Release12.2(44)SE or later (the
IP base image). However, to do this, you must first upgrade to Cisco IOS Release 12.2(40)SE2.
If you wish to upgrade from a LAN base image to the IP base image without first upgrading to Cisco
IOS Release 12.2(40)SE2, you must use one of these methods to upgrade the switch:
Use the CLI to upgrade to Cisco IOS Release 12.2(44)SE or later.
–
Use the TFTP option in CNA to upgrade to Cisco IOS Release 12.2(44)SE or later.
–
"Updates to Software Configuration Guide" section on page 18
"Updates to Command Reference Guide" section on page 36
"Updates to Getting Started Guide" section on page 50
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(40)SE1 and Later
Resolved Caveats
17