Documentation Updates - Cisco 3020 - Catalyst Blade Switch Release Note

•
•
•
•
•
•
•
•
•

Documentation Updates

This section contains these documentation updates:
•
•
•
OL-14761-01
CSCsg48163
When the flow control setting for received pause frames is enabled, the switch no longer shows the
flow control operational state as off.
CSCsh74395
When a VLAN includes multiple MAC addresses, the number of MAC addresses shown in SNMP
now matches the output of the show mac-address count vlan vlan-id privileged EXEC command.
CSCsi08513
MAC flap-notification no longer occurs when a switch is running VLAN bridge spanning-tree
protocol (STP) and fallback bridging is configured on the VLANs running STP.
CSCsi10584
Multiple Spanning-Tree Protocol (MSTP) convergence time has been improved for Cisco IOS
Release 12.2.
CSCsi63999
Changing the spanning tree mode from MSTP to other spanning modes no longer causes tracebacks.
CSCsj52956
The TxBufferFullDropCount counter no longer increments when the switch is a standalone switch.
CSCsj53001
The Total- output-drops field in the show interfaces privileged EXEC command output now
displays accurate ASIC drops.
CSCsj77933
If you enter a space before a comma in the define interface-range or the interface range global
configuration command, the space before the comma is now saved in the switch configuration.
CSCsj87991
A switch configured for Link Layer Discovery Protocol (LLDP) now correctly reports the enabled
switch capabilities in the LLDP type, length, and value (TLV) attributes.
"Updates to the Software Configuration Guide" section on page 18
"Updates to the System Message Guide" section on page 18
"Updates to Getting Started Guide" section on page 19
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(44)SE
Documentation Updates
17