The Air Soft; Setting Up Of The Air Soft; Operating Air Soft - Dynaudio Air Series User Manual

The AIR SOFT is a software editor for the AIR System monitors. All parameters controllable via the display locally on the
System Controller, as well as the Reference Level features available via the AIR Remote can be controlled via the AIR Soft
program. As your AIR monitors most likely are placed out of your immediate reach we are therefore convinced that you will
benefit from having full control over your monitor system from your PC or Mac.
Please find additional parameter explanations on pages 18-20 in this manual.
Minimum requirements
• PC running Windows 98, 2000, or XP.
• Mac computer running OS 9.2 or higher or Mac OS X.
• 64MB RAM
• 800x600 24bit screen resolution
• 1 free Serial port or USB.
Connect from Serial or USB port to any free TC
LINK connection on your AIR monitors using
ONLY the cables described on page 52.
Serial to Cat-5 cable is supplied but if an USB
port is used, an USB to Serial COM 9 port
cable must be acquired.
Navigating AIR SOFT
Network
Press to enter preset list.
Calibrate - AIR-Base
46
AIR SOFT
Installation procedure PC:
• Place the Installation CD in your CD ROM drive and
open CD contents.
• Press Setup
• Follow the instructions.
Installation procedure Mac:
• Enter the Installation CD in your CD ROM drive and
open CD contents.
• Run the installer.
• Follow the instructions.
Main Screen
Calibrate - Main Monitors
System Setup