Dynaudio Air Series User Manual page 11

To set a Master
monitor as
System Controller
the TC Link
button on the rear
panel MUST be in
out-position.
To set a Master
monitor as
System Controller
the TC Link
button on the rear
panel MUST be in
out-position.
SETUPS
5.3 Digital Setup
This illustration shows how to connect a 5.3 Digital
setup
• Center is set as System Controller by leaving out the TC
Link button on the rear panel.
• Left monitor receives both Left and LS signal. The LS
monitor is fed via the TC LINK RJ-45 connection form
Left to LS.
• Center monitor receives both Center and LFE signal. The
LFE monitor is fed via the TC LINK RJ-45 connection
from Center to LFE.
• Right monitor receives both Right and RS signal. The RS
monitor is fed via the TC LINK RJ-45 connection from
Right to RS.
• With Bass-management "off" Left and Right Subs
receives no signal.
• With Bass management "on":
- Low frequency information from Left and LS is
extracted and fed to Left Sub.
- Low frequency information from Right and RS is
extracted and fed to Right Sub.
- Low frequency information from Center is extracted,
summed with the LFE channel and fed to Center Sub.
• The Remote, AIR Soft and AIR PC-IP can be connected
to any available TC LINK Out connection.
5.3 Analog Setup
This illustration shows how to connect a 5.3 Analog
setup.
Please see description on 5.3 Digital Setup above
regarding Bass-management but notice how to connect the
Analog signals:
• Left channel to Left Input on the Left monitor.
• Left Surround channel to Right Input on the Left monitor.
• Center channel to the Left Input on the Center monitor.
• LFE channel to the Right Input on the Center monitor.
• Right channel to the Left Input on the Right monitor.
• Right Surround channel to Right Input on the Right
monitor.
• The Remote, AIR Soft and AIR PC-IP can be connected
to any available TC LINK Out connection.
The setups will ONLY operate correctly if connected
according to the illustrations!
9