Updating Mobilemapper Ce Gps Firmware - Magellan MobileMapper CE - Hiking GPS Receiver Getting Started Manual

8. When you see a message saying, "Operating system updated
successfully," tap OK on the OS Loader window.
9. Tap in the upper right of the Windows screen to exit
back to the desktop.
10.Turn off the receiver by tapping
then OK button.
11.After a few seconds, MobileMapper CE's green LED will
shut off. You may then press the power button to turn the
receiver back on.
12.You may verify that the new OS firmware has been suc-
cessfully uploaded by tapping:
>Settings>Control Panel
13.Scroll down to the Thales System Info icon. Double-tap on
this icon. Confirm that the OS F/W Version is that which you
just uploaded.
Updating MobileMapper CE GPS Firm-
ware
1. Go to ftp.magellangps.com
file (beginning with an "E" such as "E024.zip") from the /
Mobile Mapping/MM CE/Firmware folder to any folder on
your PC.
2. Open the GPS firmware zip file on your PC and extract the
files to the same directory.
3. Copy the extracted files to MobileMapper CE's SD card by
using either a card reader or ActiveSync. To use Active-
Sync, turn on MobileMapper CE and connect it to your PC
using the USB cable that runs between MobileMapper
CE's I/O module and your PC's USB port. This causes
ActiveSync to launch on your PC and connect to
MobileMapper CE as a "Mobile Device."
Note: Most MobileMapper CE users do NOT set up a part-
nership when connecting to the PC with ActiveSync, but
you can if you wish.
, then Suspend and
and copy the GPS firmware zip
61