Position Gate Operator On Gate - Chamberlain LA400 Owner's Manual

INSTALLATION
» POSITION GATE OPERATOR ON GATE

POSITION GATE OPERATOR ON GATE

NOTE: The post bracket assembly can be mounted several places on the gate post.
Refer to page 11 for mounting options.
1
Open the gate to desired open position (no greater than 100°) and hold
operator against gate.
2
Place the operator arm against gate post at the desired position. Temporarily
secure gate post bracket with clamp. The gate operator (arm) must be
level.
3
Mark mounting holes on gate for reference. Temporarily secure the gate
bracket using a clamp.
4
Align the Pull-to-Open bracket to a position as CLOSE AS POSSIBLE above
the screwdriver or dowel rod.
5
Insert hex bolt through Pull-to-Open bracket and post bracket and secure with
washer, lock washer and nut.
2
4
7" (18 cm)
15
1
3
7" (18 cm)
Hex Bolt 3/8"
5
Washer
Lock Washer
Nut