Setting The Timer (On, Off) - Chamberlain CSW200UL Owner's Manual

s i n g l e O p e r a t o r
To use the automatic close for the gate system
the timer switch should be put in the
position.
To use the push close command,
the timer should be
switched to the
"OFF" position.
Push button
once to open
gate, push
button again to
close gate.
M/S LINK
Master Board
3. use Timer on Master Board
Only. (3 to 60 seconds)
Master Board
s E T T I N g T h E T I M E R
"ON"
M a s t e r / s e c o n d O p e r a t o r s
Operators need to be connected by
Master/Second control boards are interchangeable.
w i t h T i m e r s O N
1. Turn MASTER timer ON.
2. Turn SECOND timer OFF.
NOTE: If a secondary photoelectric sensor
device is NOT used when the timer is ON, the
gate WILL hit a vehicle obstructing the gate
path before reversing during the close cycle.
w i t h T i m e r s O f f
1. Turn BOTh timers OFF.
NOTE: Push button once to open gate, push
button again to close gate.
Set timer 3 to 60
seconds.
M/S LINK. See Linking Master page 19.
31
Second Board
2. Turn Second Timer to
Maximum Counterclockwise
Setting.
Second Board