Control Board Description - Chamberlain CSW200UL Owner's Manual

Plug-In Loop Detectors
Surge Suppressor
Master/Second
Connection
W4 Jumper Wire
Plug-In Loop Wires
1HP Connection - Factory installed CSW200uL1hP™ Models.
J3 Motor, Limit Switch, Maglock/Solenoid Connection
DC2000™ Back-Up Power or Reset Switch Connection
Circuit Board Power LED - Operator power OK when ON.
Overload LED - Operator power has overloaded when ON.
On-Board 3 Button Station - Close, Stop, Open commands.
Timer - Timed close.
Gate Opening Direction Selector - Open Left, Open Right.
Gate Locked LED - Maglock/Solenoid is activated when on.
Reset Motor LED - Cycle operator power when ON.
Radio Receiver LED - Radio transmitter is activated when ON.
c O N T R O l b O A R d d E s c R I P T I O N
OmniControl™ Board Connection
Center Loop LED - Center loop detector activated when ON.
Strike Open LED - Strike connected device activated when ON.
Safety Loop LED - Safety loop detector activated when ON.
Fire Dept LED - Key Switch activated when ON.
Exit Loop LED - Exit loop detector activated when ON.
Command Processed LED - Successful command executed.
Alarm Sensor - Limited Adjustment.
Reverse Sensor - Gate hit obstruction when ON.
System On LED - Operator is successfully performing a command.
J1 Surge Suppressor Data Connection
M/S Link LED - Data being transferred between master and second
operators when ON.
15
1 HP
Board
Maglock/Solenoid
Relay Module Connection
UL Alarm Connection
Photoelectric
Sensor Connection