Pair The Sensors; Battery - Garmin GSC 10 - Speed Instructions Manual

Spoke magnet
GSC 10
Pedal
magnet
GSC 10 and Magnet
alignment
6. Loosen the screw on the
sensor arm.
7. Move the sensor arm to
within 5 mm of the spoke
magnet.
You can also tilt the GSC
10 closer to either magnet
for improved alignment.
Reset
8. Press the
the GSC 10.
The LED turns red, then
green.
9. Pedal to test the sensor
alignment.
The red LED blinks each
time the pedal magnet
passes the sensor. The
green LED blinks each
time the spoke magnet
passes the sensor arm.
NOTE: The LED blinks
for the first 60 passes after
Sensor arm
indication line
button on
EN–
a reset. Press
if you require additional
passes.
10. When everything is
aligned and working
correctly, tighten the
cable ties, the sensor arm,
and the spoke magnet.

Pair the Sensors

Pairing is the connecting of
ANT+ wireless sensors,
™
for instance your GSC 10
with an Edge. After you pair
the first time, your Edge
automatically recognizes
your GSC 10 each time it is
activated.
NOTE: The pairing settings
differ for each compatible
Forerunner and Edge model.
See your owner's manual.
GSC 10 Battery
warnInG
‹
Do not use a sharp object
to remove user-replaceable
batteries. Contact your local
waste disposal department
to properly recycle the
batteries.
The GSC 10 contains a user-
replaceable CR2032 battery.
1. Locate the circular
battery cover on the side
of the GSC 10.
Reset
again