Playback Mode - The Basics; Viewing Images - Sanyo VPC S6 - Xacti Digital Camera Instruction Manual

PLAYBACK MODE - THE BASICS

Viewing Images

You can display the still images one by one.
1. Rotate the mode dial to
turn your camera on by pressing the power switch.
2. Press the button.
The last recorded image appears on the LCD monitor
screen.
Basic information is shown by indicators on the LCD
monitor screen. To see full information display, press the
button.
3. Use the four-way controller (
images.
To view the previous image, press the four-way controller ( ).
To view the next image, press the four-way controller ( ).
• For protected images/movie clips,
"Protecting Images/Movie Clips" for further details.
• For images selected for printing with DPOF setting,
this manual titled "Setting the DPOF" for further details.)
• If there is no image stored in the internal memory or on the SD/SDHC memory card, [No image]
message will appear on the LCD monitor screen.
• You cannot enter the Playback mode from the Setup mode.
, , , , ,
) to select the desired
mark will be displayed. Refer to the section in this manual titled
or and
mark will be displayed. (Refer to the section in
100-0001 100-0001 100-0001
EN-37