Olympus 225690 - Stylus 600 6MP Digital Camera Advanced Manual page 131

Possible cause
Pictures you have taken do not appear on the monitor.
The power is off.
The camera is in the
shooting mode.
There are no pictures in
the internal memory or
on the card.
There is a problem with
the card.
The camera is
connected to a TV.
Single-frame erase and all-frame erase cannot be performed.
The pictures are
protected.
No picture is displayed on the TV when connected to the camera.
The video output signal
is incorrect.
The TV video signal
setting is incorrect.
The monitor is hard to see.
The brightness of the
monitor is not adjusted
properly.
The monitor is exposed
to direct sunlight.
Frames, titles, or calendars stored in the camera are not displayed.
There is a problem with
the internal memory and
it has been formatted.
Corrective action
Press the q button to turn the camera on in
playback mode.
Press the q button to switch to playback
mode.
[NO PICTURE] is displayed on the monitor.
Record pictures.
See "Error messages".
The monitor does not function when the
video cable is connected to the camera.
Cancel the protection of the pictures.
Set the video output signal according to the
region where used.
Set the TV to the video input mode.
Use [s] to adjust monitor brightness.
Block the sunlight with your hand.
Add frames, titles, and calendars to the
camera using OLYMPUS Master software.
Troubleshooting
Ref.
page
P. 10
P. 9
–
P. 124
P. 76
P. 78
P. 77
–
P. 88
–
–
131
9