NETGEAR WAG102NA Reference Manual page 44

NETGEAR ProSafe 802.11g Wireless Access Point WG102 Reference Manual
Table 3-1. General Information Fields
Field
Access Point Information
Access Point Name
(NetBIOS name)
Country/Region
Firmware Version
Access Point Mode
VLAN (802.1Q)
Management VLAN ID
Current IP Settings
IP Address
Subnet Mask
Default Gateway
DHCP Client
MAC Address
Current Wireless Settings
Channel/Frequency
Security Profiles
3-2
Description
The default name may be changed if desired.
The domain or region for which the wireless access point is licensed for
use. It may not be legal to operate this wireless access point in a region
other than one of those identified in this field.
The version of the firmware currently installed.
The operating mode of the WG102: Access Point, Point-to-point bridge,
Multi-point bridge or Repeater.
Indicates if VLAN support is enabled. The default is disabled.
Displays the VLAN ID.
The IP address of the wireless access point.
The subnet mask for the wireless access point.
The default gateway for the wireless access point communication.
If this is enabled, the current IP address was obtained from a DHCP
server on your network. Disabled indicates a static IP configuration.
The Media Access Control address (MAC address) of the wireless
access point's Ethernet port.
The channel the wireless port uses. The default channel setting is
automatic channel selection. For the frequencies used on each
channel, see the link to the online document
Communications" in Appendix
For each Security Profile, the following are displayed: Profile name,
SSID, security option, VLAN ID, and enabled/disabled.
v1.0, July 2008
"Wireless
B."
Management