NETGEAR WAG102NA Reference Manual page 21

NETGEAR ProSafe 802.11g Wireless Access Point WG102 Reference Manual
1. Set up the WG102 Access Point.
Tip: Before mounting the WG102 Access Point in a high location, first set up and
test the WG102 Access Point to verify wireless network connectivity.
a. Prepare a computer with an Ethernet adapter. If this computer is already part of your
network, record its TCP/IP configuration settings.
b. Configure the computer with a static IP address of 192.168.0.210 and 255.255.255.0 for
the Subnet Mask.
c. Connect an Ethernet cable from the WG102 Access Point to the computer.
d. Turn on your computer, connect the power adapter to the WG102 and verify the following:
– The PWR power light goes on.
– The LAN light of the wireless access point is lit when connected to a powered on
computer.
2. Configure LAN and wireless access.
a. Use your Web browser to connect to the WG102 Access Point.
– Enter 192.168.0.229 in the address field of your browser.
– When prompted, enter admin for the user name, and password for the password, both in
lower case letters.
Basic Installation and Configuration
v1.0, July 2008
1-5