NETGEAR WAG102NA Reference Manual page 24

NETGEAR ProSafe 802.11g Wireless Access Point WG102 Reference Manual
d. Enter the wireless settings. See the online help or
instructions.
Note: In the US, the Country/Region is preset according to regulatory
Now that you have finished the setup, you are ready to deploy the WG102 Access Point in
your network. If needed, you can now reconfigure the computer you used in for this process
back to its original TCP/IP settings.
3. Deploy the WG102 Access Point
a. Disconnect the WG102 Access Point and put it where you will deploy it. The best location
is elevated, such as wall mounted, or on the top of a cubicle, at the center of your wireless
coverage area, and within line of sight of all the mobile devices.
b. Lift the antenna on either side to be vertical.
Note: Consult the antenna positioning and wireless mode configuration
c. Connect an Ethernet cable from your WG102 Access Point to a LAN port on your router,
switch, or hub.
Note: By default, the WG102 Access Point is set with the DHCP client disabled.
d. Connect the power adapter to the wireless access point, and plug the power adapter in to a
power outlet. The PWR, LAN, and WLAN lights should light up.
4. Verify wireless connectivity
1-8
requirements. In other areas, you can and must set the Country/Region. It
may not be legal to operate the wireless access point in a region other than
one of those identified in this field.
information in the Advanced Configuration
If your network uses dynamic IP addresses, you must change this setting..
v1.0, July 2008
"Wireless Settings" on page 1-12
chapter of this manual.
Basic Installation and Configuration
for full