NETGEAR WAG102NA Reference Manual page 30

NETGEAR ProSafe 802.11g Wireless Access Point WG102 Reference Manual
5. Click Apply to save your changes.
Note: If you are configuring the WG102 Access Point from a wireless computer and you
change the SSID, channel, or security settings, you will lose your wireless connection
when you click Apply. You must then change the wireless settings of your computer to
match the new settings.
6. Configure and test your PCs for wireless connectivity.
Set up the wireless adapters of your PCs so that they all have the same SSID and channel that
you configured in the WG102 Access Point. Check that they have a wireless link and are able
to obtain an IP address by DHCP from the WG102 Access Point.
Now that your PCs can connect to the WG102 Access Point, you can configure the wireless
security. See Chapter 2, "Configuring
1-14
Security."
v1.0, July 2008
Basic Installation and Configuration