WIRELESS BROADBAND ROUTER CONFIGURATION
First make sure that the network connections are functioning normally.
This Wireless Broadband Router can be configured using Internet
Explorer 4.0 or newer web browser versions.
Login to the Wireless Broadband Router through WLAN
Before configuring the Wireless Broadband Router through WLAN, make
sure that the SSID, Channel and the WEP is set properly.
The default setting of the Wireless Broadband Router that you will use:
SSID: default
Channel: 6
WEP Encryption: disable
Login to the Wireless Broadband Router through LAN
Before you configure this device, note that when the Wireless Broadband
Router is configured through an Ethernet connection, make sure the host
PC must be set on the IP subnet that can be accessed by the Cable/DSL
modem. For example, when the default network address of the Cable/DSL
modem Ethernet interface is 192.168.1.x, then the host PC should be set at
192.168.1.xxx (where xxx is a number between 2 and 254), and the
default subnet mask is 255.255.255.0.
Using the Web Browser
1.
Open Internet Explorer 4.0 or above Internet browser.
2.
Enter IP address http://192.168.1.1 (the factory-default IP address
setting) to the URL web address location.
14