Setting Up The Projector - Epson EMP 9000 - SXGA LCD Projector Owner's Manual

Setting Up the Projector

1. Place the projector on a sturdy, level surface within five
feet of the computer or video source.
♦
Caution: Do not hold the projector by the lens. This can damage
the lens.
2. Place the projector at a correct distance from the screen.
The distance between the projector and the screen
determines the actual image size. Use the general
guidelines below to determine the correct distance.
Screen size
300 inches (610x460cm) 460.6 inches (11.7 m) ~ 586.6 inches (14.9m)
200 inches (410x300cm) 307.1 inches (7.8 m) ~ 389.8 inches (9.9 m)
100 inches (200x150cm) 153.5 inches (3.9 m) ~ 192.9 inches (4.9 m)
80 inches (160x120cm) 122.0 inches (3.1 m) ~ 153.5 inches (3.9 m)
60 inches (120x90cm)
40 inches (81x61cm)
30 inches (61x46cm)
♦
Note: The projection distance described above is for a standard
lens. When using the optional lens, refer to the Owner's manuals
attached to it.
3. Turn the projector so that the lens is at right angles to the
screen. If the projector is not angled correctly, the screen
image will be crooked.
4. Connect one end of the power cable to the projector's
power connector. Connect the other end to an earthed
electrical socket.
The projector should be in sleep mode, indicated by an
orange power indicator.
4
Horizontal distance from projector to screen
90.6 inches (2.3 m) ~ 114.2 inches (2.9 m)
59.1 inches (1.5 m) ~ 74.8 inches (1.9 m)
43.3 inches (1.1 m) ~ 55.1 inches (1.4 m)