Reports; Universal Setup Menu - Lexmark C544DTN - Color Laser Printer 25/25 Ppm Duplex Networkfront Pic User Manual

Universal Setup menu

Menu item
Units of Measure
Inches
Millimeters
Portrait Width
3–14.17 inches
76–360 mm
Portrait Height
3–14.17 inches
76–360 mm
Feed Direction
Short Edge
Long Edge

Reports

Menu Settings Page menu
Menu item
Menu Settings Page
Description
Identifies the units of measure
Notes:
Inches is the US factory default setting.
•
Millimeters is the international factory default setting.
•
Sets the portrait width
Notes:
If the width exceeds the maximum, then the printer uses the
•
maximum width allowed.
8.5 inches is the US factory default setting. Inches can be increased
•
in 0.01-inch increments.
216 mm is the international factory default setting. Millimeters can
•
be increased in 1-mm increments.
Sets the portrait height
Notes:
If the height exceeds the maximum, then the printer uses the
•
maximum height allowed.
14 inches is the US factory default setting. Inches can be increased in
•
0.01-inch increments.
356 mm is the international factory default setting. Millimeters can
•
be increased in 1-mm increments.
Specifies the feed direction
Notes:
Short Edge is the factory default setting.
•
Long Edge appears only if the longest edge is shorter than the
•
maximum length supported in the tray.
Description
Prints a report containing information about paper loaded into trays, installed
memory, the total page count, alarms, timeouts, the printer control panel
language, the TCP/IP address, the status of supplies, the status of the network
connection, and other information
Note: The page prints when this item is selected.
Understanding printer menus
73