Using Perfect Binder Pb-503; Turning On/Off The Heater Of The Perfect Binder - Konica Minolta bizhub PRO 1051 Additional Information

4
4.1

Turning On/Off the Heater of the Perfect Binder

The perfect binder has an inner heater to add heat to paste pellets for making
perfect-bound books. It requires approximately 20 minutes of warmup time
to melt the pellets to be ready for the operation. Adding heat continuously to
paste pellets, however, may deteriorate them if the perfect binder is kept un-
operated.
To prevent the deterioration of paste pellets, the heater of the perfect binder
is designed to be turned off automatically in the following condition.
- One minute after a perfect binding job is completed
- One minute after completion of the warmup if any operation has not been
made on the perfect binder
To turn on the heater of the perfect binder
Turning on the sub power switch of the main body does not turn on the heat-
er of the perfect binder at the same time to start warming up automatically.
!
Detail
The heater of the perfect binder can be set to start warming up automat-
ically with the sub power switch of the main body turned on. Please con-
tact your service representative, if desired.
bizhub PRO 1200/1051
36 bizhub PRO 1200/1200P/1051 Additional Information

Using Perfect Binder PB-503