Advertisement
Figure 6
Ethernet Circuit Boards Installed in Auxiliary Assembly
Ethernet 2
Ethernet 3
If you need to install an optional circuit board, refer to the "Installing a Circuit Board
Note
in the PIX 515E" section in the Cisco PIX Security Appliance Hardware Installation
Guide.
If you have a second PIX 515E security appliance to use as a failover unit, install the failover
feature and cable as described in the "Installing Failover" section in the Cisco PIX Security
Appliance Hardware Installation Guide.
Connect the inside, outside, or perimeter network cables to the interface ports. Starting from
Step 3
the top left, the connectors are Ethernet 2, Ethernet 3, Ethernet 4, and Ethernet 5. The
maximum number of allowed interfaces is six with an unrestricted license.
Do not add a single-port circuit board in the extra slot below the four-port circuit
Note
board because the maximum number of allowed interfaces is six.
Power on the unit from the switch at the rear to start the PIX 515E security appliance. Do not
Step 4
power on the failover units until the active unit is configured.
100 Mbps
Link
FDX
FAILOVER
100 Mbps
Link
FDX
10/100 ETHERN ET 0/0
10/100 ETHERN ET 0/0
CONSO LE
Ethernet 1
Ethernet 0
31
Advertisement
