Talk Settings - Yamaha 503 Reference Manual

Talk Settings

This function gives you special settings for making announcements between songs, separate from the settings
for your singing performance.
1
Call up the operation display.
[FUNCTION] → [G] MIC SETTING/VOCAL HARMONY → [I] MIC SETTING → TAB [E][F]
TALK SETTING
2
Use the [A]/[B] buttons to select the parameter to be adjusted, then set the value by
using the [1 ▲▼]–[7 ▲▼] buttons.
CAUTION
Settings in the TALK SETTING Page are automatically saved to the instrument when you exit from the display. However, if you turn the
power off without exiting from this display, the settings will be lost.
The settings here can be saved to USER or USB as a System Setup file: [FUNCTION] → [J] UTILITY → TAB [
NOTE
1 Talk Setting Parameters
[1 ▲▼]
[2 ▲▼]
[4 ▲▼]
[5 ▲▼]
10
[6 ▲▼]/
[7 ▲▼]
2 DSP Parameters
[3 ▲▼]
[4 ▲▼]/
[5 ▲▼]
[6 ▲▼]
82
CVP-509/505/503/501 Reference Manual
VOLUME This determines the output volume of the microphone sound.
PAN This sets the stereo pan position of the microphone sound.
REVERB These set the depth of the reverb effects applied to the microphone sound.
DEPTH
CHORUS This sets the depth of the chorus effects applied to the microphone sound.
DEPTH
TOTAL This determines the amount of attenuation to be applied to the overall
VOLUME sound (excepting the microphone input)—allowing you to effectively
ATTENUATOR adjust the balance between your voice and the overall instrument sound.
DSP MIC ON/ This turns the DSP effect applied to the microphone sound ON or OFF.
OFF
DSP MIC TYPE This selects the type of DSP effect to be applied to the microphone sound.
DSP MIC This sets the depth of the DSP effect applied to the microphone sound.
DEPTH
E F
][ ] SYSTEM RESET. See page 101.