Gigabyte GA-6UASL1 User Manual page 23

14) F_PANEL2 (Front Panel Header)
Connect the power switch, reset switch, speaker, chassis intrusion switch/sensor and system status
indicator on the chassis to this header according to the pin assignments below. Note the positive and
negative pins before connecting the cables.
The front panel design may differ by chassis. A front panel module mainly consists of power
switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your
chassis front panel module to this header, make sure the wire assignments and the pin assign-
ments are matched correctly.
Pin No. Signal Name
1 HD+
2 PWR+
3 HD-
4 PWR-
5 NA
6 SW+
7 NA
8 GND
9 NA
10 NA
11 NA
12 NA
13 NA
14 NA
15 LAN-
16 PWR+
17 LAN+
18 NA
1 2
17 18
Definition
Hard Disk LED Signal anode (+)
Power LED +
Hard Disk LED Signal cathode(-)
Power LED Signal cathode(-)
No Connect
Power Button
No Connect
Ground
No Connect
No Connect
No Connect
No Connect
No Connect
No Connect
LAN active LED Signal cathode(-)
Power LED Signal anode (+)
LAN active LED Signal anode (+)
No Connect
- 23 - Hardware Installation