Gigabyte GA-6UASL1 User Manual page 20

8) SATA0/1/2/3/4/5 (SATA 3Gb/s Connectors)
The SATA connectors conform to SATA 3Gb/s standard and are compatible with SATA 1.5Gb/s standard.
Each SATA connector supports a single SATA device.
• A RAID 0 or RAID 1 configuration requires at least two hard drives. If more than two hard
drives are configured, the total number of hard drives must be an even number.
• A RAID 5 configuration requires at least three hard drives. (The total number of hard drives
does not have to be an even number.)
• A RAID 10 configuration requires four hard drives.
(Note) When a RAID configuration is built across the SATA 3Gb/s channels, the system performance of
the RAID configuration may vary depends on the devices are connected.
9) USB1 (USB Headers)
The headers conform to USB 2.0/1.1 specification. Each USB header can provide two USB ports via an
optional USB bracket. For purchasing the optional USB bracket, please contact the local dealer.
When the system is in S4/S5 mode, only the USB ports routed to the F_USB1 header can sup-
port the ON/OFF Charge function.
Hardware Installation
1
7
10 9
2 1
- 20 -
PORT PORT PORT
Pin No. Definition
1 GND
2 TXP
3 TXN
4 GND
5 RXN
6 RXP
7 GND
Pin No. Definition
1 Power (5V)
2 Power (5V)
3 USB DX-
4 USB DY-
5 USB DX+
6 USB DY+
7 GND
8 GND
9 No Pin
10 OC