Erasing The Configuration; Changing The Administrator Password - NETGEAR WGT624v4 - 108 Mbps Wireless Firewall Router Reference Manual

108 mbps wireless router v4

Hide thumbs Also See for WGT624v4 - 108 Mbps Wireless Firewall Router:

Table of Contents

108 Mbps Wireless Router WGT624 v4 Reference Manual

Erasing the Configuration

You can restore the router to the factory default settings with the Erase function. After an erase, the

router's password will be password, the LAN IP address will be 192.168.1.1, and the router's

DHCP client will be enabled.

•

To erase the configuration, click Erase on the Backup Settings page.

•

To restore the factory default configuration settings without knowing the login password or IP

address, use the Reset button on the rear panel of the router. See

Configuration and Password" on page

The default password for the router is password. NETGEAR recommends that you change this

password to a more secure password.

To change the administrator password:

1. From the router's main menu, below the Maintenance heading, select Set Password.

Figure 4-5

2. To change the password, enter the old password, and then enter the new password twice.

3. Click Apply.

4-6

6-7.

v1.0, May 2007

"Restoring the Default

Maintenance

Table of Contents