Manual Setup; Connecting Your Wireless Router - NETGEAR WGT624v4 - 108 Mbps Wireless Firewall Router Reference Manual

Manual Setup

There are two steps to setting up your wireless router:
1. Connect the router to the ADSL or cable modem, and connect a computer to the router.
Note: Your computer has to be set to automatically get its TCP/IP network settings
from the router via DHCP. This is usually the case. If you are unsure about this,
use the wizard on the CD, which automatically takes care of this for you, or
refer to the documentation for your computer.
2. Configure the router to use your Internet service.

Connecting Your Wireless Router

To connect your wireless router:
1. Connect the wireless router, the computer, and the modem.
a. Turn off your computer.
b. Turn off and unplug the cable or ADSL broadband modem.
c. Locate the Ethernet cable (1) that connects your computer to the modem.
Figure 1-5
d. Disconnect the cable at the modem end only (2).
Connecting the Router to the Internet
108 Mbps Wireless Router WGT624 v4 Reference Manual
1
2
v1.0, May 2007
1-7