Automatic Firmware Checking On - NETGEAR DM111PSPv2 User Manual

Automatic Firmware Checking On

When automatic firmware checking is on, the modem performs the check and notifies you if
an upgrade is available or not as shown here.
Figure 9. Firmware upgrade assistant and results screen

To upgrade the firmware:
1. Click Yes to allow the modem to download and install the new firmware. The upgrade
process could take a few minutes. When the upload is complete, your modem restarts.
2. Go to the DM111PSPv2 support page at http://www.netgear.com/support, and read the new
firmware release notes to determine whether you need to reconfigure the modem after
upgrading.
Note: If you get a "Firmware needs to be reloaded" message, it means a
problem has been detected with the modem's firmware. Follow the
prompts to correct the problem, or see
Reloaded
Broadband ADSL2+ Modem DM111PSPv2
on page 72 for a description of the steps.
Network Maintenance
45
Firmware Needs to Be