Manual Programming - Lawn Genie LD6 - CO M/R IRRIGATION 6 Zone Controller Timer Operator's Manual

Off
Use this dial position to turn off watering, such as when it is
raining or you don't want watering. As long as the dial is in the
OFF position, watering programs will not be activated
automatically. The OFF position is also used to terminate all
running program A or B watering cycles, whether manual or
automatic.
1.
Set the dial to the OFF position. Valves currently watering will
be turned off after dial is in OFF position for at least two
seconds. All active programs are discontinued and watering
is stopped.
2. To return controller to normal automatic operation, simply
return dial to RUN position.
Warning: In warm weather you may experience landscape
damage if the dial is left unintentionally in the OFF position
for extended periods of time. Always return the dial to RUN
position if automatic operation is desired.
IV. Manual Programming
Manual Program Cycle
Use this feature to manually start a program. For example, this
can be used to start a program an extra time on a particularly hot
day.
1.
Set the dial to the MANUAL PROGRAM CYCLE position.
2. Select program A or B.
3. Press the + button to select manual program cycle.
4. Press the 4 button until the desired starting valve is
displayed. That valve and all subsequent valves in the selected
program will water in sequence.
5. Return the dial to the RUN position to begin the manual
watering cycle. Display shows MANUAL PROGRAM CYCLE A,
program A or B, valve number A, and counts down the remaining
run time for each active valve.