Water Days - Lawn Genie LD6 - CO M/R IRRIGATION 6 Zone Controller Timer Operator's Manual

II. Guided Programming (Optional)
In guided programming, the controller display prompts you to
enter data for items by flashing the appropriate A. It automatically
prompts you to supply information about the current time and
date, program start time(s), valve run time(s) and watering days
for program A and program B. After all items are entered
"OK" will be flashed five times to verify programming is complete.
If you have not entered the required data during the guided
programming session, the controller will flash the message "- - - - ",
and prompt you for the missing data. The purpose of guided
programming is to allow you to enter a program without this
manual.
To begin, set dial to GUlDED PROGRAM. This will lead you
through five easy Use the + and - buttons to increase or
steps .
decrease times. Use the 4 button to enter your selection and to
advance to the next step. After setting the time and date,
program A (or B) A will flash. You will be prompted to complete
program A. If required, you may continue with program B by
pressing the A/B button. After the final programming step, the
controller will flash "OK". You will then be prompted to set-up the
other program, B (or A), if desired. After all desired programming
is done, set dial to RUN position to begin automatic operation.
Hint:
Plu g in 9 volt alkaline battery t
your kitchen table .
battery.
Guided Programming Steps
1. T/ME/DAT E
- Enter the year, the month, the date and the
time. This will set the controller's internal timing. Use + and -
buttons to increase or decrease values and the 4 button to
go to the next step.
2. PROGRAM A o
r
A/B button to select. Press 4 button to go to the next step.
3.
START T/M E - Enter the program watering start time(s). Each
program can have up to two start times. (Two start times allow
watering twice a day.)
4.
,
an
to run. You may select a few minutes for a light sprinkling, or
you may set the valve to remain open for up to four hours for
applications such as drip. (The valve is off when the run time is
set to zero minutes and the display shows "OFF"). Press + or -
buttons to increase or decrease the minutes of run time per
valve. Press 4 button to go to the next valve or to the next step.
5.
WATER DAY S
You may select particular days of the week, all odd days or all
even days. Press the + button to turn days on and the - button
to turn days off. Press the 4 button to go to the next day or
to the next step.
o allow programming at
install controller after programming by
B - Select either program A or B. Press the
- Enter which days should be watering days.