Checking Your System Settings; Resetting The System; Default System Settings - Pioneer ELITE VSX-92TXH Operating Instructions Manual

Using other functions

Checking your system settings

Use the status display screen to check your current
settings for features such as surround back channel
processing and your current MCACC preset.
AUDIO SUBTITLE
DISP
PHOTO
STATUS STATUS SIGNAL SEL
MULTI OPE THX
SHIFT
PHASE
1 Press STATUS to check the system settings.
These appear on the front panel display.
The front panel display shows each of the following
settings for two seconds each:
Input source
Surround Back Processing
MCACC preset
ZONE 2 / REC SEL
ZONE 3
HDMI Control
2 When you're finished, press STATUS again to
switch off the display.
Note
1 If the Pure Direct mode is switched on, some settings above will show OFF, even though they are on.
HDD DVD
CH CH
T.DISP
STEREO/
SBch F.S.SURR
STANDARD ADV. SURR
MCACC S.DIRECT
1
↓
↓
↓
↓
↓

Resetting the system

Use this procedure to reset all the receiver's settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the SETUP button on the front
panel, press  STANDBY/ON.
The display shows RESET NO.
3 Press the ENTER button on the front panel.
Select RESET using /, then press the ENTER
4
button on the front panel.
The display shows RESET? OK.
5 Press ENTER to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.

Default system settings

Setting
HDMI Audio
Digital Video Conversion
Speakers
Surround Back System
Speaker System Front
Center
Surr.
SB
SW
Crossover
X-Curve
THX Audio Setting
Inputs
See Input function default and possible settings on page 68.
MULTI-ZONE
Zone 2 Volume Type
Zone 2 Volume
SR+
SR+ Control On/Off
SR+ Volume Control On/Off
11
Default
Amp
On
A
Normal (default)
SMALL
SMALL
SMALL
SMALLx2
YES
80 Hz
OFF
0–1ft.
Variable
-60
OFF
OFF
75
En