Reversing The Door Hinges - Asko T701 Use And Care Manual

REVERSING THE DOOR HINGES

The door hinges on ASKO dryers are reversible. The
dryers are shipped left-hinged. To reverse them, follow
the steps below:
WARNING!
Switch off the main power supply
before you start this procedure.
1. Remove the two 20 torx
screws on the bottom
of the front panel then
grasp the bottom of
the panel and pull it
forward and down.
2. Remove the three screws holding
the hinge.
3. Supporting the door from the bottom,
pull it out and to the left as you turn
the hinge counter clockwise.
4. Remove the top hinge pin.
5. Turn the hinge upside down
and put the hinge pin into the
top hole.
6. Repeat steps 2–5 for the
bottom hinge.
7. Loosen the two screws on both outer edges of the
door so you can remove the magnetic door catch
and the cover plate.
8. Remove the magnetic
catch by pushing it up
then lifting it out from
the bottom.
9. Remove the cover plate
on the opposite side of
the door by pushing it
down then lifting it out
from the top.
10. Reverse steps 8 and 9 to
place the door catch and cover plate into their new
positions.
11. Tighten the screws on the sides of the doors to hold
the magnetic catch and cover plate in place.
Page 8
12. Using a flathead screwdriver,
carefully remove the plastic plugs
in the upper and lower edge of the
door and place them in the empty
holes on the opposite side.
13. Remove the screw in the top right
corner of the front panel, as indicated
in the illustration. (If you have a
condenser dryer, you will need
to open the condenser container
door.)
14. Now you are ready to mount the door on the right
side. Holding the door at an angle (as illustrated), fit
the hinge pin into the top hole.
15. Replace the screws in the order
Hinge
illustrated at right (a, b, c).
pin
16. Replace the screw you removed
in step 13 (d).
17. (If the unit has a condenser, close
the condenser door.) Replace the front panel.
18. Turn back on the main power.