Table of Contents
Advertisement
3. Turn the bulb socket
one-quarter turn
counterclockwise, while
pressing it firmly.
4.
Remove the wire
connector from the bulb
by lifting the lock tab
and pulling it away from
the plastic base.
To reassemble, attach the wire connector (A) to the
plastic base making sure the lock tab (B) is over the
lock (C). Install the bulb by putting the small tab (D)
into the small notch in the lamp (E). Turn the bulb
socket one-quarter turn clockwise to lock into place.
When reinstalling the headlamp assembly into the
headlamp mounting panel, make sure the tab is
properly engaged in the panel slot.
Taillamps
Open the trunk. On either
side of the rear of the trunk
are two plastic nuts.
Remove only the side that
you need to access. Pull the
carpet back away from the
rear area. The taillamp,
sidemarker and back-up
lamps can now be accessed.
Advertisement
Table of Contents
