Table of Contents
Advertisement
SOURCE: Press this button to change to the tape or
disc function when the radio is on. If both a tape and a
disc are installed, the system will first go to tape play;
TAPE will appear on the display. If SOURCE is pressed
again, the system will go to disc play; CD will appear on
the display.
EJECT The system has two EJECT buttons. Press the
button near the CD slot to remove a disc. Press the button
near the tape slot to remove a tape. The radio will play.
CLN: This message may appear on the display. If it
does, your cassette tape player needs to be cleaned. It
will still play tapes, but you should clean it as soon as
possible to prevent damage to your tapes and player. See
"Care of Your Cassette Tape Player" in the Index. After
you clean the player, press and hold EJECT for five
seconds to reset the CLN indicator. The radio will
display --- to show the indicator was reset.
Your cassette tape player automatically reduces
background noise from tapes encoded with Dolby
N R .
You may
turn
Dolby off by pressing the number six preset.
Dolby Noise Reduction is manufactured under a license
from Dolby Laboratories Licensing Corporation. Dolby
and the double-D symbol are trademarks of Dolby
Laboratories Licensing Corporation,
Playing a Campact Disc
Insert a disc partway into the slot, label side up. r n e
player will pull it in. The disc should begin playing.
If you want to insert a CD while the ignition or the radio
is off, first press EJECT or RECALL.
If you're driving on a very rough road or if it's very hot,
the disc may not play and an error code may appear on
the display. Press RECALL to take the error code off the
display. When things get back to normal, the disc should
play. If the disc comes out, it could be that:
0
The disc is upside down.
0
It is dirty, scratched or wet.
0
It is very humid. (If so, wait about an hour and
try again.)
RECALL: Press this button to see which track is
playing. Press
it
again within
five
seconds
to see how
long
it
has been playing. To change what is normally
shown on the display (track or elapsed time), press the
RECALL button until you see the display you want,
then hold the RECALL button until the display flashes.
3-25
Advertisement
Table of Contents
