Advertisement
SCAN: Press this button to hear each station for a few
seconds. The radio will go to
a
station, stop for
a
few
seconds, then go on to the next station. SCAN appears
on
the display. Press SCAN again to stop scanning.
PUSHBUTTONS: The four numbered pushbuttons let
you return to your favorite stations. You can set up to
14 stations (seven AM and seven FM).
1. Find the station you want by using TUNE.
2. Press SET. (The SET indicator will appear briefly on
3. Press one of the four pushbuttons, within five
the display.)
seconds. Whenever you press that numbered button,
the station you set will return.
4. Repeat the steps for each pushbutton.
In addition to the four stations set
as
above, up to three
additional stations may be preset on each band by
pressing two adjoining buttons at the same time. Just:
1. Tune in the desired station.
2. Press SET. (The SET indicator will appear on the
3. Press any two adjoining pushbuttons at the same
4. Whenever you press the same buttons, the station
display.)
time (within five seconds).
you set will return.
Setting the Tone
BASS: Slide this lever up to increase bass and down to
decrease it.
TREBLE: Slide this lever up to increase treble and
down to decrease it.
If a
station is weak or noisy, slide
the lever down to reduce the noise.
Adjusting the Speakers
BAL: This control behind the upper knob adjusts the
sound between the right and left speakers.
FADE: This control behind the lower knob adjusts the
sound between your front and rear speakers.
Playing a Cassette Tape
Your tape player is built to work best with tapes that are
30 to 45 minutes long on each side. Tapes longer than
that are so thin they may not work well in this player.
While the tape is playing, use the VOL, FADE, BAL,
TREBLE and BASS controls just as you do for the
radio. The display will show an arrow to show which
side of the tape is playing. When the right indicator
arrow is lit, selections listed on the bottom side of the
cassette are playing. When the left arrow is lit,
selections listed on the top side of the cassette are
playing. The tape player automatically begins playing
the other side when it reaches the end of the tape.
3-7
Advertisement
