Installing Your Bycicle - MINOURA RDA INTERRIM ERGO Manual

Mag unit must be assembled on the left side
!
of RDA Trainer and the Assistant Roller Unit
on the right. Do not mistake directions, see
diagram for accurate placement. After
deciding the height of the pulleys tighten
handle securely to avoid damage to equip-
ment and/or rider. (see Fig. D)
Handle with care! Damage may occur if Mag unit is dropped.
!
Install the assistant roller unit to the right side of the frame, using
3
the same process as with the left-side Mag unit. Make sure the
assembly is secure and accurate. (see Fig. E)
The Inter-Rim is foldable and portable without requiring future
disassembly of the Magturbo unit and assistant roller unit.
The Magturbo unit must be on the left side of the Inter-Rim Ergo's
!
frame, and the assistant roller unit must be on the right side.
Both drive pulleys must be adjusted so as not to touch the tire.
You do not need to set this adjustment at this stage of the assem-
bly --- you can adjust it later, before use. Once you have set the
height of the pulleys, you must fix them firmly. If they are loose,
they may break and/or damage your bicycle.
INSTALLING YOUR BICYCLE
Before installing your bicycle, rotate both hub-clamp handles counter-clockwise to
1
create a wide clearance between the couplings. (see Fig. F)
Place the bicycle's rear hub between the two couplings,
2
making sure that the quick-release skewer (or hub nut) is not
yet touching either couplings. Then rotate the hub-clamp
handles clockwise to fix the rear hub. Tighten until securely
fastened, but do not overtighten.
During this attachment process, you should adjust the
position of the rim with checking the Rim Center Position
Indicator on the Assitant Roller. (see Fig. G)
- 4 -
(Fig. D)
(Fig. E)
(Fig. F)
(Fig. G)