Using The Magturbo Unit; Options; Decreasing Load Force; Increasing Load Force - MINOURA RDA INTERRIM ERGO Manual

To remove your bicycle from the trainer:
4
First, push down both yellow levers, which releases the
rollers and drive pulleys from the bicycle rim, and then
rotate the hub-clamp counter-clockwise until loose, and pull
out the bicycle. (see Fig. K)

USING THE MAGTURBO UNIT

The Magturbo unit has seven different levels of load force, replicating actual riding resistance.
The load settings range from high (H) to low (L) and can be adjusted via the yellow lever on the
Magturbo unit. The rider may also adjust the load force by shifting up or down among his gears,
depending on the level desired.
We recommend that you start with a medium to low load force and gradually work up, increasing force
as muscled warm up.
To decrease the load force, move the yellow lever on Mag unit toward
the (L) symbol. The lowest selection is not zero load; there still be a
small level of force.
When your Mag unit is a remote control type, twist the lever on your
handlebar toward the (L) symbol.
To increase the load force, move the yellow lever on the Mag unit
toward the (H) symbol.
When your Mag unit is a remote control type, twist the lever on your
handlebar toward the (H) symbol.
You must not be riding the Inter-Rim trainer when you are adjusting the yellow lever
!
for load force. Make sure all parts have stopped spinning. Do not try to adjust the
lever with your feet while riding.

OPTIONS

In 1998 Minoura is offering an option to the RDA Magturbo system called "ICE (Interactive Cycling
Experience)" system.
This computerized option will give the rider continuous automatic load changes according to pre-
programmed software supplied by UltraCoach in California, U.S.A..
This easy-to-install unit provides a more enjoyable and accurate training experience.
- 6 -
(Fig. K)