Assembling - MINOURA RDA INTERRIM ERGO Manual

ASSEMBLING YOUR MINOURA TRAINER
Mag Unit
Remote Control
Lever
Mag unit installation
slot
Open the frame and U-Leg and place on level floor.
1
Prior to assembly of the Magturbo unit, locate the
2
two bolts and two washers. Locate the left-side slot
on the Minoura trainer. While placing the Magturbo
unit at the desired position on the inside of the slot,
attach it with bolts and washers by using the included
hex wrench. (see Fig. B)
After installing the Magturbo unit, put the Height
Adjust Knob (maybe an option) through the hole on
the pre-installed bracket on the left side slot, and then
tighten it to the thread on the Magturbo support base.
This optional Height Adjust Knob will help your
adjustment of Magturbo's height in order to fit the
rubber roller properly to the rim side wall. (see Fig.C)
Mag Unit Height
Adjust Knob
Assistant roller unit
installation slot
Couplings
Hub-clamp handle
Drive roller
Rubber Foot Cap
- 3 -
Frame
U-Leg
Drive-pulley lever
(Fig. A)
(Fig. B)
(Fig. C)