Installing Your Bicycle - MINOURA MAGTURBO ERGO Manual

INSTALLING YOUR BICYCLE

Before attaching your bicycle to this trainer, turn the Hub Handle in a counter-
1
clockwise direction to open the trainer enough to easily line up your rear quick
release (QR) with the Couplings. This will make it easier to attach the rear hub
of your bicycle.
Do NOT oepn the Hub Handle too far. Otherwise the inside Nylon nut located
in the metal cap of the Hub Handle may come loose.
Loosen the Knob Bolt enough until the wheel can be placed without touching
2
the Drive Roller on Mag resistance unit. You may need to manually move the
drive roller. This is O.K. and won't hurt the mag unit.
Install the rear hub between the couplings. (see Fig. C)
3
While holding your bicycle, tighten the Hub Handle in a clockwise direction
until you see the couplings come in contact, and engage the heads of your QR
lever.
Stop tightening the handle after the couplings have engaged the QR.
4
You should NOT be able to move the bicycle without also moving the trainer. If
the bicycle moves within the couplings AT ALL, continue to tighten the handle
until you see no movement of the bicycle within the couplings.
Please be sure not to tighten the couplings past the point that the bicycle does
move within the couplings. Over tightening can cause both your bicycle and
trainer to sustain damage.
Be sure to check this each time you use your trainer.
- 4 -
(Fig. C)