MINOURA HYPERRIM Manual page 5

Once you have set the correct position of the rim for your bicycle, you can install or
Notes
remove your bicycle by rotating only one hub-clamp handle. This feature saves
time.
The Left-side coupling has a cut-away section to accomodate the shaft of the quick-
!
release lever. You must align this coupling with the shaft of the QR. Failure to do
so may cause the coupling to improperly support the bicycle.
The couplings are designed to acommodate a certain style of quick-release lever.
!
If you use an incompatible quick-release lever, it may not be properly supported be
the coupling --- so you must change your quick-release to the correct style in order
to prevent accidents.
The white levers control the release and placement of the rollers to the rim. By adjusting these
3
levers, you will see that the two rollers contact the rim sidewall with equal tension.
If they are not resting on the rim properly, but on the tire, then you must re-adjust the height of
the drive pulleys so that the roller contact is solely on the rim. (see Fig. G)
If the rollers are rubbing against or touching
!
the tire, it may cause the tire to burst.
Roller-to-rim contact ONLY! (see Fig. H)
Be careful not to pinch fingers in springs while adjusting.
!
(see Fig. I)
- 5 -
(Fig. G)
(Fig. H)
(Fig. I)