Related Manuals for MINOURA HYPERMAG ALU-LW Series
Summary of Contents for MINOURA HYPERMAG ALU-LW Series
- Page 1 All manuals and user guides at all-guides.com HyperMag ALU-LW series indoor bicycle trainer instructions manual - 1 -...
- Page 2 All manuals and user guides at all-guides.com SCHEMATIC HF-7 M8-3 HF-4 HM-11 HM-12 HM-2 M8-3 HM-14 HM-3 HM-7 HM-4 / HM-5 HM-8 HM-9 HM-13 LM-13 F-1 : Coupling (Right) HM-2: Flywheel Side Inner Case F-4 : Coupling Cover (move side) HM-3: Mag Side Inner Case F-7 :...
-
Page 3: Important Notes
• The trainer is manufactured to precise standards. You may not disassemble or rebuild it. • "Magturbo" is the trademarks of Minoura Co.,Ltd. and may not be copied. • "Magturbo" is the trademarks of Minoura Co.,Ltd. and may not be copied. - Page 4 All manuals and user guides at all-guides.com HOW TO SETUP YOUR HYPER-MAG TRAINER Open the frame support legs and fit the rubber feet at the correct angle so the base is in full contact with the floor. Do NOT remove the round metal plates from inside the rubber feet when fitting. Ensure the rubber foot caps are facing outwards as incorrect fitting may compromise the stability of the trainer.
- Page 5 All manuals and user guides at all-guides.com At this point, stop tightening the hub handle and ensure that both ends of the skewer are securely inserted into the couplings. Finally turn the hub handle a maximum of two more turns to ensure the bicycle is held firmly. NOTE: NOTE: NOTE: Over-tightening the hub handle may cause damage to either the trainer...
- Page 6 The right side coupling has a black plastic skewer nut protector (called a “Grommet”). This is to protect your skewer from damage during use. Minoura cannot guarantee compatibility with all makes and models of skewer, however when using your own skewer please use the supplied grommet.
- Page 7 All manuals and user guides at all-guides.com USING THE MAG RESISTANCE UNIT The Mag unit has 7 different levels of load force, replicating actual riding resistance. The load settings range from high (H) to low (L) can be adjusted via the white lever on the Magturbo unit or the lever on the thumb shifter type remote lever device.
- Page 8 1197-1 Godo, Anpachi, Gifu 503-2305 JAPAN Fax +81-584-27-7505 / E-mail: minoura@minoura.jp http://www.minoura.jp MINOURA NORTH AMERICAN WARRANTY CENTER (for U.S. Residents only) MINOURA NORTH AMERICAN WARRANTY CENTER (for U.S. Residents only) MINOURA NORTH AMERICAN WARRANTY CENTER (for U.S. Residents only) MINOURA NORTH AMERICAN WARRANTY CENTER (for U.S. Residents only) MINOURA NORTH AMERICAN WARRANTY CENTER (for U.S.