Exit Roller Unit - Brother hl 1650 - B/W Laser Printer Service Manual

3.26

Exit Roller Unit

NOTE:
Be sure to disconnect all the connectors on the fan relay PCB before removing the exit roller
unit.
(1) Remove the two shoulder screws to remove the exit roller unit from the printer.
(2) Remove the two bind B M4x10 Taptite screws to remove the exit roller holder from the exit
roller unit.
(3) Lift up and remove the pinch roller ASSY from the exit roller unit, and then remove the
pinch roller spring from the pinch roller ASSY.
(4) Remove the cup B M3x8 Taptite screw to remove the rear cover sensor PCB ASSY from
the unit.
Exit roller holder
Pinch roller ASSY
Taptite, cup B M3x8
Rear cover sensor PCB ASSY
Adhesive tape
Shoulder screws
Fig. 4-96
Pinch roller ASSY
Adhesive tape
Fig. 4-97
4-55
&+$37(5  ',6$66(0%/< $1' 5($66(0%/<
Exit roller unit
Taptite, bind B M4x10
Exit roller ASSY ZLh
Pinch
roller spring
Exit roller unit