Table of Contents
Advertisement
Drivers Installation
This board is equipped with Jack Sensing capability. If an audio device is plugged
into the wrong connector, a warning message will appear to remind users to check
the connection.
9. Push "Start" button to start the sensing. Please remember to terminate all
audio applications before starting the sensing.
10. EZ-Connection shows the result of the detection.
"Audio Connector" column reflects the settings used in the "Speaker
Configuration" page.
"Current Connection" column shows the type of device detected. If the
results do not match, an exclamation mark will appear on the right side.
Page 5-6
Connector
Sensing:
<Figure 9>
Connector
Sensing:
<Figure 10>
Advertisement
Table of Contents
