Table of Contents
Advertisement
Installation
SATA1
CUSB4
CUSB3
Please make sure the USB cable has the same pin assignment. A different pin assignment
may cause damage to the system. If you need the USB cable, please contact our retailer.
Page 3-12
SATA1 / SATA2: Two Serial ATA Connectors
These connectors enable you to connect two Serial
ATA devices that conform to the Serial ATA
specification.
SATA2
LED1: 80 Port Debug LED
Provides two-digit POST code to show why the
system fail to boot. Allows quick and easy
optimization.
80 Port Debug 7-segment LED display
(Refer to Appendix C for POST codes)
CUSB3/CUSB4: Four USB 2.0 ports
This mainboard includes 2 additional USB2.0 ports,
identified by two 10-pin connector.
If you wish to use the additional USB ports, install
the card-edge bracket to the system chassis then
insert its cables to this 10-pin connector.
CAUTION !
1
B+
A+
GND
B-
A-
GND
GND
Advertisement
Table of Contents
