Ignition Switch - HYOSUNG GV 650 C Owner's Manual

STARTER SWITCH
Use this switch to operate the starting
motor.
With the ignition switch in the "ON" posi-
tion, the engine stop switch in the "
position, and the transmission is in neutral,
squeeze the clutch lever and the side stand
up and push the starter switch to start the
engine.
When the ignition switch is set to "ON"
position with the engine stopped, the meter
lamp will come on and the needle of the
speedometer will turn once to the end as a
test of electric system operation.
Push the starter switch after the needle of
the speedometer turn back.
CAUTION
In case of
not attempt the start the engine until
the needle of the speedometer com-
pletes a full sweep and returns to the
rest position otherwise the engine will
start badly.
If the engine does not start or runs
badly, turn the ignition switch to the
"OFF" position. After 8 seconds, turn
the ignition switch on, allow the
speedometer needle to complete it's
sweep and return to the rest position
and then attempt to restart. This
allows the ISC (Idling Speed Control)
solenoid to be initialized.
Release the starter switch immediate-
ly after the motorcycle has started.
"
Do not engage the starting motor for
more than five seconds at a time as it
may overheat the wiring harness and
starting motor.
If the engine does not start after sever-
al attempts, check the fuel supply and
igintion system. (Refer for Page 79 )
with the side stand ignition interlock
system.
If the transmission is in neutral or side
stand up, you can only start the engine
, do
by pulling in the clutch lever.
This side stand ignition interlock system
prevents the motorcycle from being
started with side stand down.
Make sure that the side stand ignition
interlock system is working properly
before riding.
The head lamp, position lamp, meter
lamp, tail lamp and license plate lamp on
this motorcycle always comes on when
the ignition switch is turned to the "ON"
position.
29
CAUTION
WARNING
is equipped
CAUTION