Engine Oil Level Check; Engine Oil And Filter Change; Engine Oil Capacity - HYOSUNG GT250 FI Owner's Manual

ENGINE OIL
Long engine life depends much on the
selection of quality oil and the periodic
changing of the oil.
Daily oil level checks and periodic
changes are two of the most important
maintenances to be performed.
◉ ◉ ENGINE OIL LEVEL CHECK
Follow the procedure below to inspect the
engine oil level.
1. Start the engine and run it for a few
minutes.
2. Stop the engine and wait three
minutes.
3. Hold the motorcycle vertically and
inspect the engine oil level through the
engine oil level lens on the right side on
the engine.
CAUTION
"Fuel and Engine oil" use certainly to
recommend at the front part.
Never operate the motorcycle if the
engine oil level is below the "Lower line
mark (L)" in the engine oil level lens.
Never fill the engine oil above the
"Upper line mark (F)". Engine oil level
being most suitable about 1mm under
the "Upper line mark (F)" of the engine
oil level lens. In case of the engine oil
pouring excessively, the engine output
being made insufficient.
Be careful not to pour the engine oil
excessively.
◉ ◉ ENGINE OIL AND FILTER CHANGE
Change the engine oil and filter, after first
running 1,000 km and every running 4,000
km.
The oil should always be changed when
the engine is hot so that the oil will drain
thoroughly from the engine. The procedure
is as follows.

ENGINE OIL CAPACITY

Oil change
Oil and filter change
Engine overhaul
In case of the engine oil pouring
excessively, the engine output being
made insufficient.
Be careful not to pour the engine oil
excessively.
1. Place the motorcycle on the jack or
block.
36
CAUTION
1,450 ㎖
1,500 ㎖
1,800 ㎖
CAUTION