6. Turn the bulb counterclockwise and remove it.
7. Unplug the electrical connector.
8. Put the new bulb into the lens assembly and turn it
clockwise until it is tight.
9. Plug in the electrical connector.
10. Put the headlamp lens assembly back into the
vehicle. Install and tighten the two bolts.
11. Install the two turn signal bulb sockets and the
sidemarker bulb socket into the parking/turn signal
bulb assembly.
12. Install the parking/turn signal assembly. Install and
tighten the two phillips
6-36
-
head screws.
Parking/Turn Signal Lamps
For the procedure to remove the parking/turn signal
lamps and sidemarker lamps, see "Headlamps"
previously in this section.
Fog Lamps
1. The fog lamp bulb assembly is located under the
front bumper.
2. Remove the fog lamp bulb socket by turning it
counterclockwise.
yellowblue