Table of Contents
Advertisement
Training a Garage Door Opener with a
"Rolling Code" Feature
If you programmed the universal transmitter, but the
garage door will not open, and if your garage door
opener was manufactured after 1995, your garage door
may have a security feature that changes the "code" of
your garage door opener every time it is opened
or closed.
To determine if your garage door opener has this
"rolling code" feature, press the appropriate button on
the universal transmitter that was programmed. If the
red light flashes rapidly for one to two seconds, then
turns solid, your garage door opener has this feature.
To program a garage door opener with the rolling code
feature, do the following:
-
1. Program your hand
held transmitter to the universal
transmitter by following the steps provided under
"Programming the Transmitter" earlier in
this section.
2-66
2. Remove the cover panel from the garage door
opener receiver. It is located near the garage door
opener motor.
3. Locate the training button on the garage door opener
receiver. The exact location and color will vary
among brands.
4. Press the training button on the garage door opener
receiver for one to two seconds.
5. Return to your vehicle and press the programmed
button on the universal transmitter until the red light
flashes rapidly (about two seconds).
6. Release the button, then press it again to confirm
that it was programmed to the garage door
opener receiver.
You may now use either the universal transmitter or the
-
hand
held transmitter to open your garage door. If you
still have difficulty in programming and require
-
assistance, please call 1
800
-
-
355
3515.
yellowblue
Advertisement
Table of Contents
