Acquiring An Image From A Multifunction Machine; Using The Network Scanner Tool To Acquire An Image - Sharp PN-L702B Operation Manual

Acquiring an Image From a Multifunction Machine

If a SHARP multifunction machine is connected to the same network as the computer on which the Pen Software is installed, an
image scanned on the multifunction machine can be acquired onto the whiteboard.
TIPS
• Supports the Network Scanner Tool 3.3 or higher (as of August, 2011).
• For details, contact your dealer or nearest authorized service representative for the multifunction machine.
• For the procedures for using the multifunction machine, see the manual for the multifunction machine.

Using the Network Scanner Tool to acquire an image

The first time you use the Network Scanner Tool, install the Network Scanner Tool on the computer on which the Pen Software
has been installed and configure the Network Scanner Tool settings. (Page 24)
To acquire an image from a multifunction machine, the Network Scanner Tool must be running on your computer.
Use JPEG for the scan send format.
n In the multifunction machine
1. Place the document in the multifunction machine.
2. Select a destination stored in the Network Scanner Tool.
3. Select JPEG for the scan send format.
4. Execute scanning.
The document will be scanned and sent to the Pen Software.
n In the Pen Software (whiteboard mode)
When the image has been sent, the
5. Touch the "Receive the printed or scanned images" button.
The first sheet of the acquired image appears.
"Receive the printed or scanned images" button will blink.
19
E