Related Manuals for Sharp On-line Manual Video Capture
Summary of Contents for Sharp On-line Manual Video Capture
- Page 1 On-line Manual LITE VERSION Video Capture Software IMPORTANT INFORMATION CONTENTS SV Photo Capture SV Card Link Troubleshooting Please read this operation manual carefully before using your software.
-
Page 2: Table Of Contents
G The contents of the on-line manual have been prepared with care. If, however, you should have any doubts or notice any errors, please contact Sharp Corporation. G PixLab (hereafter referred to as “this software”) is copyrighted by Sharp Troubleshooting ................ -
Page 3: Sv Photo Capture
SV Photo Capture SV Photo Capture CONTENTS CONTENTS PREVIOUS PAGE NEXT PAGE PREVIOUS PAGE NEXT PAGE SV Photo Capture can be used to control the VIEWCAM Edge smoothing AUTO button Use this to capture images connected to the computer from the computer and capture images Connection with correction. -
Page 4: Capturing Images
CONTENTS CONTENTS PREVIOUS PAGE NEXT PAGE PREVIOUS PAGE NEXT PAGE Capturing images Click when the image you want to capture is displayed. • The image stops moving (a still image is displayed) and Use the mode select buttons to choose the mode. •... -
Page 5: Saving Images
CONTENTS CONTENTS PREVIOUS PAGE NEXT PAGE PREVIOUS PAGE NEXT PAGE Saving images VIEWCAM operation while SV Photo Capture is running Select the folder in which the image is to be saved. • If still picture or slow playback is performed continuously for •... -
Page 6: Sv Card Link
SV Card Link SV Card Link CONTENTS CONTENTS PREVIOUS PAGE NEXT PAGE PREVIOUS PAGE NEXT PAGE SV Card Link can be used to capture still pictures stored on a VIEWCAM’s media card directly into your computer. This function can only be used if your VIEWCAM is equipped with Note a media card. -
Page 7: Exitting
CONTENTS CONTENTS PREVIOUS PAGE NEXT PAGE PREVIOUS PAGE NEXT PAGE Select the folder in which the still images are to be Exitting saved. To quit SV Card Link, click With SV Card Link, the connection settings are set automatically. These settings can also be set manually. 1) Click 2) Set the serial port and transfer speed. -
Page 8: Troubleshooting
Troubleshooting Troubleshooting CONTENTS CONTENTS PREVIOUS PAGE PREVIOUS PAGE G Is the power saving function turned on? If there are communications errors or For some computers, turning on the power saving (power communications are unstable... management) function may interfere with communications. G Are the VIEWCAM and computer connected properly? Refer to your computer’s operating instructions and turn the power saving function off before starting up SV Photo...