About The Atapi/E-Ide Interface - Yamaha CRW2100SZ - CRW - CD-RW Drive Quick Start Manual

4.2) About the E-IDE (ATAPI) Interface
The most common standard for connecting internal hard drives and CD-ROM drives inside a
PC is the E-IDE (ATAPI) interface.
E-IDE or Enhanced IDE computers normally have two IDE interface connectors; a primary
and a secondary. Each IDE interface connector allows up to two IDE devices to be connect-
ed for a total of four IDE devices. Typically, a hard disk is connected to the primary connec-
tor while a CD-ROM drive is attached to the secondary connector.
Important Note : Avoid connecting your new CD-RW 3-in-1 drive to the same primary IDE connector as the
one connected to your hard drive if possible. Select the secondary connector that may be connected to your
CD-ROM drive. But, if you must connect it to the primary connector, make sure there is only one device (your
hard drive) selected as MASTER and all other devices are selected as SLAVE.
4.2.1) Rear panel of CRW2100EZ (E-IDE)
The CRW2100EZ drive's rear panel features the following:
DIGITAL AUDIO OUT connector
If your sound card has a digital audio
input, you can connect this connector
to that digital input using a digital
audio cable (sold separately).
AUDIO OUT
DIGITAL ANALOG
D G
ANALOG AUDIO
OUT connector
Connect one end
of the 4-pin audio
cable to this and
the other end to
your computer's
sound card or
built-in audio.
CSEL
SLAVE
MASTER
R G L
IO OUT
G L
1 MASTER jumper switch
Plug a plastic shunt into this jumper switch if you are
connecting the master CRW2200EZ/EDK using an IDE
cable.
2 SLAVE jumper switch (default setting)
Plug a plastic shunt into this jumper switch if you are
connecting the slave CRW2200EZ/EDK using an IDE cable.
3 CSEL jumper switch
If your computer supports the CSEL function, plug a
plastic shunt into this jumper switch to have the
computer automatically select master or slave for the
CRW2200EZ/EDK.
IDE INTERFACE connector
Insert the connector of the IDE cable
here. Make sure you align the red line
of the ribbon cable with pin 1 of the
drive's connector, marked "IDE
INTERFACE CONNECTOR 1."
1
CSEL
SLAVE
MASTER
13
IDE
INTERFACE
CONNECTOR
DC INPUT
+ 5V + 12V
G
DC INPUT
connector
Insert the power
connector from your
computer's power
supply in this
socket to feed
power to the drive.